Replacement Bootwiper Brushes

Our boot wipers are built to take a beating, but even the toughest brushes wear down over time. Constant use, especially during wet and muddy seasons, means the bristles will eventually lose their stiffness.

This set of four replacement brushes is all you need to get your bootwiper back to its best. Specifically designed for our Square Pattern Bootwiper, this kit provides a direct replacement for worn-out originals.

The set comes complete with all the necessary fixings, making the job quick and straightforward. You can have the old ones off and the new ones on in a matter of minutes. No need to replace the whole steel unit – just swap out the brushes and you’re good to go. It’s a simple, practical way to maintain your equipment and keep the clubhouse entrance clean.

How It Works

• Unscrew the fixings holding the old brushes to the bootwiper frame.
• Remove the worn brushes.
• Position the new brushes in place.
• Secure them firmly using the new fixings provided.

FAQ

Q: Will these fit any bootwiper?

A: These are specifically designed for the BMS Square Pattern Bootwiper to ensure a perfect fit.

Q: Are fixings included?

A: Yes, a full set of replacement fasteners is included with the four brushes.

Q: How many brushes are in a set?

A: This is a complete set of four brushes, enough to fully refurbish one bootwiper unit.